All guides / Printing
How to print board game PDFs at the right size
Fix scale, clipped margins, and uneven card backs with a one-sheet test.
Start with the right paper size
A4 measures 210 × 297 mm. US Letter measures 215.9 × 279.4 mm. A4 is narrower and taller, so choosing the wrong size can clip a sheet even when it looks fine on the screen. Use the file that matches the paper in your tray when the designer provides both. If there is only one version, check the preview with the actual tray size selected.
Measure one component before printing the set
Open the downloaded PDF and choose Actual Size or 100% scale. Print one page that contains a scale bar or a component with a known size. Measure between its cut marks with a ruler. If a 63 mm card prints 60 mm wide, the sheet came out roughly 5% small. Check both your PDF application's scaling and any separate fit option in the printer driver before trying again.
Diagnose clipping separately from scaling
When a card measures correctly but a corner mark is missing, the content may be too close to your printer's non-printable margin. Try the alternate paper layout or a version with fewer cards per sheet. If the pieces must fit a sleeve or line up with a board, keep the same scale throughout the build. Some borderless modes enlarge an image slightly, so measure another copy if you switch that setting on.
Print an oversized board across several sheets
If the designer supplies a tiled PDF for your paper size, print those sheets at Actual Size. For a board supplied as one oversized PDF page, select just that page and use Poster printing in Adobe Acrobat. Set Tile Scale to 100%, add about 6 mm (¼ in) of overlap, and enable cut marks. Check the preview for the number and arrangement of sheets before printing.
Print the board on plain paper first. Check a known dimension with a ruler, ideally across a seam. At each join, trim the margin on one tile and keep the overlap on its neighbor. Line up a grid line or printed detail, then tape the sheets together from the back before mounting the board.
Make a duplex test with ordinary paper
Draw an arrow along the top of a blank sheet and mark the side facing up in the tray. Print only one front-and-back pair. Hold it to the light and check whether the tops match and the backs sit inside the cut lines. Long-edge and short-edge flipping change the orientation of the back. If the back shifts on successive tests, sleeves with opaque backs are a simpler solution for hidden decks.
Save the settings that worked
Write down the PDF version, printer, paper size, scale, and duplex setting. If an inkjet print smudges, give the sheet time to dry and check the driver’s media setting. Once the sample is the right size, legible, and dry, print the rest of the set in batches so you can catch a feed problem before it affects every sheet.
Updated